How To Fix Leaks And Holes In A Rubber Roof ?

Rubber roofs are one of the most preferable roofs as they can last really long. Moreover, they can easily be repaired and put to work again in very small time. Due to this durable and hassle free qualities, it is used all over the world especially in commercial buildings.

The first thing you need to do is to mark out the tainted areas. Wipe off the tainted areas with a broom and then highlight them with the help of a chalk or tape. Check for the well being of seams all around and pay special attention to the areas near vents, chimneys, skylights etc. You can take the help of a probing tool for inspection job.

Next, clean the marked spots with warm water and let them air dry. Treat the top and bottom of the rubber seam by rubbing alcohol. The alcohol would wipe out any of the remaining pieces of adhesive that are still lying on the rubber seam.

Put an appropriate amount of EPDM on the top and bottom of side of the seam respectively. Now, put them on place and apply gentle pressure so that they can join. Roll silicon roller over and over again until the adhesive begins to set.

With the help of a probing tool, check for any further leaks after 24 hours of repairing. Also apply seam tape on the seams in order to prevent them from future leaks.

In case you want to repair a hole in the roof, you need to cut away the part of the roof that contains the hole. Secure the integrity of the substrate material in the roof. You need a replacement piece to put in the hole. You can buy it from a home improvement center. Use a sharp knife to cut it such that it fits the hole. Install it in place.

Now, cut a length of rubber roofing material of proper measurement. Clean the work site and also the bottom side of the replacement rubber material. Coat the whole bottom side of the replacement rubber material with rubber cement. When cement dries off, turn it up and coat cement on the roof opening too. Compress it tightly until it starts to set.

Always stick to the safety standards while repairing is in process. Use high quality materials to bind the rubber to the intended place.

Scott Rodgers is a fine expert who has been authoring on roofing contents for a long time now. His extraordinary guidance has given motivation to a host of workers, ranging from Lafayette Roofers (Need one? click here!) to Grand Junction Roofers (Need one? click here!).